Argox AS-8000 Manuel d'instructions télécharger pdf (Page 3)

Introduction

Installation- Keyboard Wedge

1) First of all, you must switch off power for the

terminal/computer.

2) Disconnect the keyboard cable from the back of the

terminal/computer.

3) Connect the appropriate interface cable to the scanner

and to the terminal/computer.

4) Turn the terminal/computer power on.

RS-232

1) Disconnect power to the terminal/computer.

2) Connect the appropriate interface cable and external

power supply (DC adapter) to the scanner.

3) Plug the serial connector into the serial port on the back

of your computer/terminal. Tighten the two screws to

secure the connector to the port.

4) Plug the power pack into power source.

5) Once the scanner has been fully connected, turn the

terminal/computer power back on.

USB (Simulate with keyboard wedge)

1) Connect the USB cable between scanner and PC.

2) Windows will automatically detect the USB device.

Note: If any of the above operation is incorrect, turn off the

power immediately and check any improper

connections. Go through all above steps again.

Note: If you need more programming parameters to setup

your ArgoScan scanner, please go to

www.argox.com and download the completed user’s

manual.

1 2 3 4 5 6 7 8 ... 32 33

A 27 Nov 2024 | 06:23:28

Argox AS-8000 Manuel d'instructions Page 3