Argox AS-8020CL Manuel d'utilisateur télécharger pdf (Page 7)

Installation

The AS-8020CL Wireless Imager is easy to install and use.

Please see the following figure showing the steps to perform

the installation.

* Note: Turn off the host computer before installation.

1. Connect the interface (I/F) cable to the cradle.

2. Connect the power cord to the cradle.

3. Route the I/F cable and power cord through the notch.

4. Connect the I/F cable to the host computer

communication port.

5. Connect the AC adapter to the wall outlet.

6. Place the imager in the cradle and verify the charge

LED is flashing. Charge the battery for at least 8 hours

before the first use.

7. To verify operation, please link the imager with cradle

first (Refer to “Wireless Connection” in page 12). Point

the imager at the barcode and pull the trigger. The

imager should emit a beep indicating that the barcode

has been scanned and transmitted to the cradle

successfully.

1 2 3 4 5 6 7 8 9 10 11 12 ... 144 145

Pas de commentaire

Argox AS-8020CL Manuel d'utilisateur Page 7