Argox F1 Manuel d'utilisateur télécharger pdf (Page 10)

2. After the adjustment above, ribbon wound ink-side out can be

used. Then install the ribbon:

3. If ribbon wound ink-side in is in use, pull and move the

SHAFT RIBBON ADJ

to “Inside”. Then install the ribbon:

Loading Media

The X-Series printers offer three different loading modes:

standard, peel-off, or with a cutter.

 Standard mode allows you to collect each label freely.

 Peel-off mode peels backing material away from the label

as it prints. After the label is removed, the next label prints.

 Cutter mode automatically cuts the label after it prints.

Note:

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 62 63

Pas de commentaire

Argox F1 Manuel d'utilisateur Page 10