Argox F1 Manuel d'utilisateur télécharger pdf (Page 7)

Peel Off Mode

Cutter Mode

Loading Ribbon

Note: Thermal Transfer printing requires media to print with

appropriate ribbon. This section can be referred to, for X-Series

to use transfer thermal printing. The sample steps below are

based on ribbon wound ink-side in as an example.(X series

printers use ribbon wound ink-side in as default. To change

setting to ribbon would ink-side out, refer to Section - Switching

Ribbon Wound Ink-side out or Ink-side in)

1. Lift the top cover and front access door to expose the

media compartment. (Figure 1)

2. Turn the head latch counter-clockwise and open the

bracket. (Figure 2)

1 2 3 4 5 6 7 8 9 10 11 12 ... 62 63

Pas de commentaire

Argox F1 Manuel d'utilisateur Page 7