Argox OS-214ZIP Spécifications télécharger pdf (Page 35)

Caring for Your Printer

After using eight rolls of label stock, clean the following areas of

the printer.

Note: Turn off the printer before cleaning.

Cleaning

Clean the following components of the printer using a cotton bud

dampened with alcohol. Do not soak the cotton bud excessively.

Thermal Print Head

Thermal paper stock and the ribbon release debris on the print

head, which degrades printing quality. Clean the print head with

methanol or isopropyl alcohol and a cotton bud. Do not touch the

heater element with your fingers. Debris or dirt on the roller

should be cleaned with alcohol.

Paper Sensor

Debris or dirt on the paper sensor can cause a miss-read or

unstable detection of the label gap. Clean with a cotton bud

dampened with alcohol.

Replacing the Thermal Print Head

1. Switch off the power and wait for both LEDs to go off.

2. Unlatch the print head module.

3. Remove the ribbon.

4. Push the print head firmly into the casing and shift it to the

left. It will release from the module.

5. Disconnect the print head cable.

6. Disassemble the print head and the mounting bracket by

releasing screws.

7. Replace with a new print head. Reassemble the print head

module in reverse order. Be careful not to touch the print

head elements.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 45 46

Pas de commentaire

Argox OS-214ZIP Spécifications Page 35