Argox OS Series Spécifications télécharger pdf (Page 40)

19. Click the top cover back onto the middle cover.

20. Insert the sensor connector into its receptacle on the main

logic board of the base housing.

21. Click the middle cover back into the base housing. First

click in the front then the rear.

22. Secure the two screws at the bottom of the base housing.

H. Cover

Middle Cover

4 mm Gap

Appendix II - Installing the Cutter

1. Turn off the printer power and unplug the power cable and

Centronics / Serial cable.

2. Remove the top cover.

3. Remove the two screws under the base housing.

1 2 ... 35 36 37 38 39 40 41

Pas de commentaire

Argox OS Series Spécifications Page 40